I first published some of my old print backlist as ebooks starting with a cleaned Word document, set styles, then.er, I can't find my notes and can't remember, but it was through Calibre conversion. Please share your thoughts and ideas in the comments section and I’ll reply as soon as I can.I've searched Literature & Latte, the web, KB, and can't find this particular problem. There are many other settings so take time to learn those according to your project parameters. I hope this helps when you compile a manuscript. Again, make sure to save your settings for the compiler so you don’t change then constantly or forget to check settings that you think should be default but aren’t. This is changed by clicking on Page Settings on the left of the Compiler where you can then choose a consistent font. However, when you compile you may find the header/footer is different. I have my default set to Times New Roman. When you create the document make sure your font is set to the one you want to use throughout the document. Do this consistently and choose the document rather than the folder when compiling and your results will be more of what you expect.Įxtra tip # 2: Use font choices for you project and also in your headers/footers. When you create your chapters in the binder, create a folder, then a document within it. Once you’ve saved a preset you can load it by clicking on the Load Preset button in the lower left and scrolling down the list of standard presets to My Presets and choosing the one you want based on your needs.Įxtra tip # 1: Use a consistent folder/document structure. However, you can also save your custom presets by clicking Save Presets in the lower left. When you re-open the Compiler and choose Custom from the menu these will remain. To save these custom settings click Save and Close on the lower right. I checked that and made sure that page one was counter by checking the second box. Not that “Not on ” is not checked by default. My screen shot above also shows an example. To do this click on Page Settings from the left menu of the Compiler and then type in or change the header settings. In my case I removed any text I didn’t want and added a few details. Here you can edit the beginning layout of a section. To change the layout of a section click on a level to highlight it and then on the Selection Layout button. This removed folder titles being used as chapter names so that only the chapter numbers remain. When you start making changes it will change the “Format As:” to Custom.įor my purposes, the necessary changes were made by first clicking on Formatting and turning off all the check marks for title. Click on Contents and verify that everything for your manuscript is selected. You can use these to change settings in the compiler. Note all the different categories on the left menu. But no biggie, I started poking around and found settings in the compiler to help me get the manuscript to the appearance I wanted.įirst, click on File and then Compile to open the Compiler: This is likely because I originally used a general template rather than one specific to a novel. The folder names became chapter titles and labeled scenes appeared in the text.
My first attempt did not work as I expected. However, I did want chapters without titles and a header.
I wasn’t concerned with the format of my manuscript since it was consistent.
#SCRIVENER COMPILE FORMATTING TRIAL#
There was some trial and error so here are a few things I learned along the way including some extra tips at the end. For a book there were a few more details required than I had previously experienced. I had compiled for a short story so that was rather easy. When I first began sending manuscript version of The Bow of Destiny to my editor, the manuscript needed compiling which I had never done for a book.
With that in mind, here’s a quick primer to get you going, make sure to consult your version of Scrivener with the Compiler settings and check the instructions for more details. But getting everything can be a bit tricky if you haven’t compile a manuscript previously. This is a point at which you are ready to extract the manuscript from Scrivener and begin editing so it’s important to have useful results that you want when you compile. Happy Monday to everyone! PH back in the house with some additional Scrivener tips, this week covering some compiling basics.
0 kommentar(er)
